542 Upgrade and Maintenance Manual RX2540 M4
System board and components
If a password is assigned, enter the password and press [Enter].
Ê Select the Save & Exit menu.
Ê Select Save Changes and Exit or Save Changes and Reset.
Ê Verify that the Global Error indicator stops flashing.
Ê "Updating or recovering the BIOS and iRMC S5" on page 96
Ê If applicable, activate TPM functionality in the system BIOS under Security
> TPM (Security Chip) Setting > Security Chip. For more information, see
the corresponding BIOS Setup Utility Reference Manual.
Ê "Verifying system information backup/restore" on page 99
Ê "Verifying the system time settings" on page 109
Ê "Looking for MAC/WWN/GUID and SAS addresses" on page 115
Ê "Updating the NIC configuration file in a Linux and VMware environment" on
page 112
Ê "Resuming BitLocker functionality" on page 112
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I Configuration of network settings should be performed by the
customer. For more information, see section "Note on network
settings recovery" on page 536.
Ê If applicable, restore LAN teaming configurations, see section "After
replacing the system board" on page 99.
To Next Page
Loading...
