Fujitsu PRIMERGY RX2540 M4

RX2540 M4 Upgrade and Maintenance Manual 557
Appendix A
iRMC-related status signals
I For further information, see section "Updating or recovering the BIOS
and iRMC S5" on page 96.
HDD/SSD prefailure detection
Depending on your hardware configuration HDD/SSD prefailure detection will
be supported.
The requirements are:
– iRMC S5 Firmware 1.2 or later
– supported OOB RAID system
ID indicator
Global error
indicator
Description
blue flashing off
A remote connection has been
established. Local VGA output has
been disabled during the remote
session.
blue flashing orange flashing
An emergency flash of the iRMC
firmware is in progress.