1-19
Default Level
2: System level
Parameters
closing: CLOSING state of a TCP connection.
established: ESTABLISHED state of a TCP connection.
fin-wait-1: FIN_WAIT_1 state of a TCP connection.
fin-wait-2: FIN_WAIT_2 state of a TCP connection.
last-ack: LAST_ACK state of a TCP connection.
syn-received: SYN_RECEIVED state of a TCP connection.
connected-number number: Maximum number of TCP connections in a certain state. The argument
number is in the range of 0 to 500.
Description
Use the tcp state command to configure the maximum number of TCP connections in a state. When
this number is exceeded, the aging of TCP connections in this state will be accelerated.
Use the undo tcp state command to restore the default.
By default, the maximum number of TCP connections in each state is 5.
Note the following points:
z You need to enable the protection against Naptha attack before executing this command.
Otherwise, an error will be prompted.
z You can respectively configure the maximum number of TCP connections in each state.
z If the maximum number of TCP connections in a state is 0, the aging of TCP connections in this
state will not be accelerated.
Related commands: tcp anti-naptha enable.
Examples
# Set the maximum number of TCP connections in the ESTABLISHED state to 100.
<Sysname> system-view
[Sysname] tcp anti-naptha enable
[Sysname] tcp state established connection-number 100
tcp syn-cookie enable
Syntax
tcp syn-cookie enable
undo tcp syn-cookie enable
View
System view
Default Level
2: System level
To Next Page
Loading...
Need help?
General