H3C S5120-SI Series

1-2
display habp table
Syntax
display habp table
View
Any view
Default Level
1: Monitor level
Parameters
None
Description
Use the display habp table command to display HABP MAC address table entries.
Note that this command is only applicable on an HABP server to display the MAC address entries
collected by the HABP server.
Examples
# On the HABP server, display HABP MAC address table entries.
<Sysname> display habp table
MAC Holdtime Receive Port
001f-3c00-0030 53 GigabitEthernet1/0/1
Table 1-2 display habp table command output description
Field Description
MAC MAC address
Holdtime
Lifetime of an entry in seconds. The initial value is three times of the interval to
send HABP request packets. An entry will age out if it is not updated during the
period.
Receive Port Port that learned the MAC address
display habp traffic
Syntax
display habp traffic
View
Any view
Default Level
1: Monitor level