1-5
Table 1-2 display icmp statistics command output description
Field Description
bad formats Number of input wrong format packets
bad checksum Number of input wrong checksum packets
echo Number of input/output echo packets
destination unreachable Number of input/output destination unreachable packets
source quench Number of input/output source quench packets
redirects Number of input/output redirection packets
echo reply Number of input/output replies
parameter problem Number of input/output parameter problem packets
timestamp Number of input/output time stamp packets
information request Number of input information request packets
mask requests Number of input/output mask requests
mask replies Number of input/output mask replies
information reply Number of output information reply packets
time exceeded Number of input/output expiration packets
display ip socket
Syntax
display ip socket [ socktype sock-type ] [ task-id socket-id ]
View
Any view
Default Level
1: Monitor level
Parameters
socktype sock-type: Displays the socket information of this type. The sock type is in the range 1 to 3,
corresponding to TCP, UDP and raw IP respectively.
task-id: Displays the socket information of this task. Task ID is in the range 1 to 150.
socket-id: Displays the information of the socket. Socket ID is in the range 0 to 3072.
Description
Use the display ip socket command to display socket information.
Examples
# Display the TCP socket information.
<Sysname> display ip socket
SOCK_STREAM:
To Next Page
Loading...
Need help?
General