1-1
1 IGMP Snooping Configuration Commands
IGMP Snooping Configuration Commands
display igmp-snooping group
Syntax
display igmp-snooping group [ vlan vlan-id ] [ verbose ]
View
Any view
Default Level
1: Monitor level
Parameters
vlan vlan-id: Displays the IGMP snooping multicast group information in the specified VLAN, where
vlan-id is in the range of 1 to 4094. If you do not specify a VLAN, this command will display the IGMP
snooping multicast group information in all VLANs.
verbose: Specifies to display the detailed IGMP snooping multicast group information.
Description
Use the display igmp-snooping group command to view the IGMP snooping multicast group
information.
Examples
# View the detailed IGMP snooping multicast group information in VLAN 2.
<Sysname> display igmp-snooping group vlan 2 verbose
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Port flags: D-Dynamic port, S-Static port, C-Copy port
Subvlan flags: R-Real VLAN, C-Copy VLAN
Vlan(id):2.
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Router port(s):total 1 port.
GE1/0/1 (D) ( 00:01:30 )
IP group(s):the following ip group(s) match to one mac group.
IP group address:224.1.1.1
(0.0.0.0, 224.1.1.1):
To Next Page
Loading...
Need help?
General