1-3
Description
Use the acl copy command to create an IPv4 ACL by copying an IPv4 ACL that already exists. Except
the number and name (if any), the new ACL has the same configuration as the source ACL.
You can assign a name for an IPv4 ACL only when you create it. After it is created, you can neither
rename it nor remove its name, if any.
Examples
# Create ACL 2002 by copying ACL 2001.
<Sysname> system-view
[Sysname] acl copy 2001 to 2002
acl name
Syntax
acl name acl-name
View
System view
Default Level
2: System level
Parameters
acl-name: Specifies the name of an existing ACL, which is a case insensitive string of 1 to 32 characters.
It must start with an English letter.
Description
Use the acl name command to enter the view of an existing ACL by specifying its name.
Related commands: acl.
Examples
# Enter the view of ACL flow.
<Sysname> system-view
[Sysname] acl name flow
[Sysname-acl-basic-2001-flow]
description
Syntax
description text
undo description
View
Basic ACL view, advanced ACL view, Ethernet frame header ACL view
To Next Page
Loading...
Need help?
General