1-3
The Maximum Transmit Unit is 1500
Internet protocol processing : disabled
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 000f-e249-8050
Last clearing of counters: Never
Last 300 seconds input: 0 bytes/sec 0 packets/sec
Last 300 seconds output: 0 bytes/sec 0 packets/sec
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
Table 1-1 display interface vlan-interface command output description
Field Description
Vlan-interface2 current state
The physical state of the VLAN interface, which can be one of
the following:
z DOWN ( Administratively ): The administrative state of the
VLAN interface is down because it has been manually shut
down with the shutdown command.
z DOWN: The administrative state of this VLAN interface is
up, but its physical state is down. It indicates that the VLAN
corresponding to this interface does not contain any port in
the UP state (possibly because the ports are not physical
connected or the lines have failed).
z UP: both the administrative state and the physical state of
this VLAN interface are up.
Line protocol current state
The link layer protocol state of a VLAN interface, which can be
one of the following:
z DOWN: The protocol state of this VLAN interface is down,
usually because no IP address is configured.
z UP: The protocol state of this VLAN interface is up.
Description The description string of a VLAN interface
The Maximum Transmit Unit The MTU of a VLAN interface
Internet protocol processing :
IP packets processing ability. Disabled indicates that the
interface is not configured with an IP address.
IP Packet Frame Type IPv4 outgoing frame format
Hardware address MAC address corresponding to a VLAN interface
Last 300 seconds input: 0
bytes/sec 0 packets/sec
Last 300 seconds output: 0
bytes/sec 0 packets/sec
Average rate of input packets and output packets in the last 300
seconds (in bps and pps)
0 packets input, 0 bytes, 0 drops
Total number and size (in bytes) of the received packets of the
interface and the number of the dropped packets
0 packets output, 0 bytes, 0 drops
Total number and size (in bytes) of the transmitted packets of
the interface and the number of the dropped packets
display vlan
Syntax
display vlan [ vlan-id1 [ to vlan-id2 ] | all | dynamic | reserved | static ]