1-22
interface-type interface-number: Type and number of the interface through which the Telnet client sends
packets.
Description
Use the telnet command to Telnet to another switch from the current switch to manage the former
remotely. You can terminate a Telnet connection by pressing <Ctrl + K>.
Related commands: display tcp status, ip host.
Examples
# Telnet to the switch with the host name of Sysname2 and IP address of 129.102.0.1 from the current
switch (with the host name of Sysname1).
<Sysname1> telnet 129.102.0.1
Trying 129.102.0.1 ...
Press CTRL+K to abort
Connected to 129.102.0.1 ...
**************************************************************************
* Copyright (c) 2004-2009 Hangzhou H3C Tech. Co., Ltd. All rights reserved.*
* Without the owner's prior written consent, *
* no decompiling or reverse-engineering shall be allowed. *
**************************************************************************
<Sysname2>
telnet client source
Syntax
telnet client source { ip ip-address | interface interface-type interface-number }
undo telnet client source
View
System view
Default Level
2: System level
Parameters
None
Description
Use the telnet client source command to specify the source IP address or source interface for the
Telnet packets to be sent.
Use the undo telnet client source command to remove the source IP address or source interface
configured for Telnet packets.
By default, source IP address or source interface of the Telnet packets sent is not configured.
To Next Page
Loading...
Need help?
General