H3C S5120-SI Series Command Reference

1-6
Field Description
Status
PoE state: enabled/disabled
z enabled: PoE is enabled.
z disabled: PoE is disabled.
Priority
Power priority of a PoE interface:
z critical (highest)
z high
z low
CurPower Current power of a PoE interface
Operating Status
Operating state of a PoE interface
z off: PoE is disabled.
z on: Power is supplied for a PoE interface
normally.
z power-lack: The guaranteed remaining
power of the PSE is not high enough to
supply power for a critical PoE interface.
z power-deny: The PSE refuses to supply
power. The power required by the powered
device (PD) is higher than the configured
power.
z power-itself: The external equipment is
supplying power for itself.
z power-limit: The PSE is supplying a limited
power. The power required by the PD is
higher than the configured power and the
PSE still supplies the configured power.
IEEE class PD power class defined by IEEE
Detection Status
Power detection state of a PoE interface:
z disabled: The PoE function is disabled.
z searching: The PoE interface is searching
for the PD.
z delivering-power: The PoE interface is
supplying power for the PD.
z fault: There is a fault defined in 802.3af.
z test: The PoE interface is under test.
z There is a fault other than defined in 802.3af.
z pd-disconnect: The PD is disconnected.
port(s) on
Number of PoE interfaces that are supplying
power
consumed Power consumed by the current PoE interface
Remaining Total remaining power of the system
display poe interface power
Syntax
display poe interface power [ interface-type interface-number ]
View
Any view

H3C S5120-SI Series Specifications

General

Brand	H3C
Model	S5120-SI Series
Category	Switch
Language	English