1-4
Examples
# Enable HABP.
<Sysname> system-view
[Sysname] habp enable
habp server vlan
Syntax
habp server vlan vlan-id
undo habp server
View
System view
Default Level
2: System level
Parameters
vlan-id: ID of the VLAN in which HABP packets are to be transmitted, in the range 1 to 4094.
Description
Use the habp server vlan command to configure HABP to work in server mode and specify the VLAN
in which HABP packets are to be transmitted.
Use the undo habp server command to configure HABP to work in the default mode.
By default, HABP works in client mode.
Note that in a cluster, if a member device with 802.1X authentication or MAC authentication enabled is
attached with some other member devices of the cluster, you also need to configure HABP server on
this device. Otherwise, the cluster management device will not be able to manage the devices attached
to this member device. For information about the cluster function, see Cluster Management
Configuration.
Examples
# Configure HABP to work in server mode and specify the VLAN for HABP packets as VLAN 2.
<Sysname> system-view
[Sysname] habp server vlan 2
habp timer
Syntax
habp timer interval
undo habp timer
View
System view
To Next Page
Loading...
Need help?
General