1-46
Description
Use the timer command to set the interval to send handshake packets.
Use the undo timer command to restore the default.
By default, the interval to send handshake packets is 10 seconds.
Note that:
z This command can be executed on the management device only.
z This configuration is valid for all member devices in a cluster.
Examples
# Configure the interval to send handshake packets as 3 seconds on the management device.
<Sysname> system-view
[Sysname] cluster
[Sysname-cluster] ip-pool 10.1.1.1 24
[Sysname-cluster] build aaa
[aaa_0.Sysname-cluster] timer 3
topology accept
Syntax
topology accept { all [ save-to { ftp-server | local-flash } ] | mac-address mac-address | member-id
member-number }
undo topology accept { all | mac-address mac-address | member-id member-number }
View
Cluster view
Default Level
2: System level
Parameters
all: Accepts the current cluster topology information as the standard topology information.
mac-address mac-address: Specifies a device by its MAC address. The device will be accepted to join
the standard topology of the cluster.
member-id member-number: Specifies a device by its member number. The device will be accepted to
join the standard topology of the cluster. The member-number argument is in the range 0 to 255.
save-to: Confirms the current topology as the standard topology, and backs up the standard topology
on the FTP server or local flash in a file named “topology.top”.
Description
Use the topology accept command to confirm the current topology information and save it as the
standard topology.
Use the undo topology accept to delete the standard topology information.
Note that:
z This command can be executed on the management device only.
To Next Page
Loading...
Need help?
General