1-22
Examples
# Set the output channel for the log information of VLAN module to snmpagent and to output
information with severity being emergency. Log information of other modules cannot be output to this
channel; other types of information of this module may or may not be output to this channel.
<Sysname> system-view
[Sysname] info-center source default channel snmpagent log state off
[Sysname] info-center source vlan channel snmpagent log level emergencies state on
# Set the output channel for the log information of VLAN module to snmpagent and to output
information with severity being emergency. Log information of other modules and all the other system
information cannot be output to this channel.
<Sysname> system-view
[Sysname] info-center source default channel snmpagent debug state off log state off trap
state off
[Sysname] info-center source vlan channel snmpagent log level emergencies state on
info-center synchronous
Syntax
info-center synchronous
undo info-center synchronous
View
System view
Default Level
2: System level
Parameters
None
Description
Use the info-center synchronous command to enable synchronous information output.
Use the undo info-center synchronous command to disable the synchronous information output.
By default, the synchronous information output is disabled.
To Next Page
Loading...
Need help?
General