1-29
storm-constrain control
Syntax
storm-constrain control { block | shutdown }
undo storm-constrain control
View
Ethernet port view
Default Level
2: System level
Parameters
block: Blocks the traffic of a specific type on a port when the traffic detected exceeds the upper
threshold.
shutdown: Shuts down a port when a type of traffic exceeds the corresponding upper threshold. A port
shut down by the storm constrain function stops forwarding all types of packets.
Description
Use the storm-constrain control command to set the action to be taken when a type of traffic exceeds
the corresponding upper threshold.
Use the undo storm-constrain control command to restore the default.
By default, no action is taken when a type of traffic exceeds the corresponding threshold.
Examples
# Configure to block interface GigabitEthernet 1/0/1 when a type of traffic reaching it exceeds the
corresponding upper threshold.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] storm-constrain control block
storm-constrain enable log
Syntax
storm-constrain enable log
undo storm-constrain enable log
View
Ethernet port view
Default Level
2: System level
Parameters
None
To Next Page
Loading...
Need help?
General