3-5
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] dhcp-snooping information enable
[Sysname-GigabitEthernet1/0/1] dhcp-snooping information strategy replace
[Sysname-GigabitEthernet1/0/1] dhcp-snooping information format verbose
dhcp-snooping information remote-id format-type
Syntax
dhcp-snooping information remote-id format-type { ascii | hex }
undo dhcp-snooping information remote-id format-type
View
Layer 2 Ethernet port view, Layer 2 aggregation interface view
Default Level
2: System level
Parameters
ascii: Specifies the code type for the remote ID sub-option as ascii.
hex: Specifies the code type for the remote ID sub-option as hex.
Description
Use the dhcp-snooping information remote-id format-type command to configure the code type for
the non-user-defined remote ID sub-option.
Use the undo dhcp-snooping information remote-id format-type command to restore the default.
By default, the code type for the remote ID sub-option is HEX.
Note that:
This command applies to configuring a non-user-defined remote ID sub-option only. After you configure
the padding content for the remote ID sub-option using the dhcp-snooping information remote-id
string command, ASCII is adopted as the code type.
Related commands: display dhcp-snooping information.
Examples
# Configure the code type for the non-user-defined remote ID sub-option as ascii.
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] dhcp-snooping information remote-id format-type ascii
dhcp-snooping information remote-id string
Syntax
dhcp-snooping information [ vlan vlan-id ] remote-id string { remote-id | sysname }
undo dhcp-snooping information [ vlan vlan-id ] remote-id string
To Next Page
Loading...
Need help?
General