1-40
[Sysname-cluster] ip-pool 10.1.1.1 24
[Sysname-cluster] build aaa
[aaa_0.Sysname-cluster] holdtime 30
ip-pool
Syntax
ip-pool ip-address { mask | mask-length }
undo ip-pool
View
Cluster view
Default Level
2: System level
Parameters
ip-address: Private IP address of the management device in a cluster.
{ mask | mask-length }: Mask of the IP address pool of a cluster. It is an integer or in dotted decimal
notation. When it is an integer, it ranges from 1 to 30. A network address can be obtained by ANDing this
mask with the private IP address of the administrator device. The private IP addresses of all member
devices in a cluster belong to this network segment.
Description
Use the ip-pool command to configure a private IP address range for cluster members.
Use the undo ip-pool command to remove the IP address range configuration.
By default, no private IP address range is configured for cluster members.
Note that:
z You must configure the IP address range on the management device only and before establishing
a cluster. If a cluster has already been established, you are not allowed to change the IP address
range.
z For a cluster to work normally, the IP addresses of the VLAN interfaces of the management device
and member devices must not be in the same network segment as that of the cluster address pool.
Examples
# Configure the IP address range of a cluster.
<Sysname> system-view
[Sysname] cluster
[Sysname-cluster] ip-pool 10.200.0.1 20
logging-host
Syntax
logging-host ip-address
undo logging-host
To Next Page
Loading...
Need help?
General