H3C S5120-SI Series Command Reference

1-11
Field Description
Cluster
Role of the device in the cluster:
z Member switch of cluster aaa: The device is a member
device of the cluster aaa.
z Administrator switch of cluster aaa: The device is the
management device of the cluster aaa.
z Candidate switch: The device is a candidate device of
cluster aaa.
z Independent switch: The device is connected to the cluster,
but it has not joined the cluster. This may be because the
cluster function is not enabled on the device.
Administrator MAC MAC address of the management device
Peer MAC
MAC address of a neighbor device
Peer Port ID
Name of the peer port connected to the local port
Native Port ID Name of the local port to which a neighbor device is connected
Speed Speed of the local port to which a neighbor device is connected
Duplex
Duplex mode of the local port to which a neighbor device is
connected
ntdp enable
Syntax
ntdp enable
undo ntdp enable
View
System view, Ethernet interface view, Layer 2 aggregate interface view
Default Level
2: System level
Parameters
None
Description
Use the ntdp enable command to enable NTDP.
Use the undo ntdp enable command to disable NTDP.
By default, NTDP is enabled globally and on all ports.
Note that:
z Execution of the command in system view enables the global NTDP; execution of the command in
interface view enables NTDP of the current port.
z Configured in Layer 2 aggregate interface view, the configuration will not take effect on the member
ports of the aggregation group that corresponds to the aggregate interface; configured on a
member port of an aggregation group, the configuration will take effect only after the member port

H3C S5120-SI Series Specifications

General

Brand	H3C
Model	S5120-SI Series
Category	Switch
Language	English