H3C S5120-SI Series

1-23
port-group manual
Syntax
port-group manual port-group-name
undo port-group manual port-group-name
View
System view
Default Level
2: System level
Parameters
port-group-name: Specifies name of a port group, a string of 1 to 32 characters.
Description
Use the port-group manual command to create a port group and enter port group view.
Use the undo port-group manual command to remove a port group.
By default, no manual port group is created.
Examples
# Create a port group named group1.
<Sysname> system-view
[Sysname] port-group manual group1
[Sysname-port-group-manual-group1]
port bridge enable
Syntax
port bridge enable
undo port bridge enable
View
Ethernet port view
Default Level
2: System level
Parameters
None
Description
Use the port bridge enable command to enable bridging on an Ethernet port. When bridging is
enabled on an Ethernet port, the device forwards packets received on the interface through the
receiving interface itself when both the following conditions are met: