2-12
View
RADIUS scheme view
Default Level
2: System level
Parameters
ip-address: IPv4 address of the primary accounting server.
port-number: UDP port number of the primary accounting server, which ranges from 1 to 65535 and
defaults to 1813.
Description
Use the primary accounting command to specify the primary RADIUS accounting server.
Use the undo primary accounting command to remove the configuration.
By default, no primary RADIUS accounting server is specified.
Note that:
z The IP addresses of the primary and secondary accounting servers cannot be the same. Otherwise,
the configuration fails.
z The RADIUS service port configured on the device and that of the RADIUS server must be
consistent.
z You can use the commands to change the settings only when no user is using the RADIUS
scheme.
Related commands: key, radius scheme, state.
Examples
# Specify the IP address of the primary accounting server for RADIUS scheme radius1 as 10.110.1.2
and the UDP port of the server as 1813.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] primary accounting 10.110.1.2 1813
primary authentication (RADIUS scheme view)
Syntax
primary authentication ip-address [ port-number ]
undo primary authentication
View
RADIUS scheme view
Default Level
2: System level
Parameters
ip-address: IPv4 address of the primary authentication/authorization server.
To Next Page
Loading...
Need help?
General