1-2
Default Level
1: Monitor level
Parameters
None
Description
Use the display lacp system-id command to display the system ID of the local system.
The system ID comprises the system LACP priority and the system MAC address.
You can use the lacp system-priority command to change the LACP priority of the local system. When
you do that, the LACP priority value you specify in the command is in decimal format. However, it is
displayed as a hexadecimal value with the display lacp system-id command.
Related commands: lacp system-priority.
Examples
# Display the local system ID.
<Sysname> display lacp system-id
Actor System ID: 0x8000, 0000-fc00-6504
Table 1-1 display lacp system-id command output description
Field Description
Actor System ID: 0x8000,
0000-fc00-6504
The local system ID, which comprises the LACP system priority
(0x8000 in this sample output) and the system MAC address
(0000-fc00-6504 in this sample output).
display link-aggregation member-port
Syntax
display link-aggregation member-port [ interface-list ]
View
Any view
Default Level
1: Monitor level
Parameters
interface-list: Link aggregation member port list, in the form of interface-type interface-number [ to
interface-type interface-number ], where interface-type interface-number indicates port type and port
number.
Description
Use the display link-aggregation member-port command to display the detailed link aggregation
information on the specified member port(s) or all member ports if no interface is specified.
To Next Page
Loading...
Need help?
General