EasyManuals Logo

H3C S5120-SI Series Command Reference

H3C S5120-SI Series
910 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #191 background imageLoading...
Page #191 background image
1-25
[Sysname-GigabitEthernet1/0/1] stp loop-protection
stp max-hops
Syntax
stp max-hops hops
undo stp max-hops
View
System view
Default Level
2: System level
Parameters
hops: Maximum hops, in the range of 1 to 40
Description
Use the stp max-hops command to set the maximum hops of the MST region on the device.
Use the undo stp max-hops command to restore the maximum hops to the default setting.
Setting the maximum hops of MST regions is to limit the sizes of MST regions. By default, the maximum
number of hops of an MST region is 20.
Related commands: display stp.
Examples
# Set the maximum hops of the MST region on the device to 35.
<Sysname> system-view
[Sysname] stp max-hops 35
stp mcheck
Syntax
stp mcheck
View
System view, Layer 2 Ethernet port view, Layer 2 aggregate port view
Default Level
2: System level
Parameters
None
Description
Use the stp mcheck command to carry out the mCheck operation globally or on the current port.

Table of Contents

Other manuals for H3C S5120-SI Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the H3C S5120-SI Series and is the answer not in the manual?

H3C S5120-SI Series Specifications

General IconGeneral
BrandH3C
ModelS5120-SI Series
CategorySwitch
LanguageEnglish

Related product manuals