1-20
igmp-snooping query-interval
Syntax
igmp-snooping query-interval interval
undo igmp-snooping query-interval
View
VLAN view
Default Level
2: System level
Parameters
interval: Interval between IGMP general queries, in seconds. The effective range is 2 to 300.
Description
Use the igmp-snooping query-interval command to configure the interval between IGMP general
queries.
Use the undo igmp-snooping query-interval command to restore the default setting.
By default, the IGMP general query interval is 60 seconds.
This command takes effect only if IGMP snooping is enabled in the VLAN.
Related commands: igmp-snooping enable, igmp-snooping querier, igmp-snooping
max-response-time, max-response-time.
Examples
# Enable IGMP snooping and set the interval between IGMP general queries to 20 seconds in VLAN 2.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping query-interval 20
igmp-snooping report source-ip
Syntax
igmp-snooping report source-ip { ip-address | current-interface }
undo igmp-snooping report source-ip
View
VLAN view
Default Level
2: System level
To Next Page
Loading...
Need help?
General