H3C S5120-SI Series Command Reference

1-12
Field Description
Admin status
LLDP mode of the port, which can be:
z TxRx. A port in this mode sends and receives LLDPDUs.
z Rx_Only. A port in this mode receives LLDPDUs only.
z Tx_Only. A port in this mode sends LLDPDUs only.
z Disable. A port in this mode does not send or receive
LLDPDUs.
Trap Flag Indicates whether trap is enabled.
Polling interval LLDP polling interval. A value of 0 indicates LLDP polling is disabled.
Number of neighbors Number of the LLDP neighbors connecting to the port
Number of MED neighbors Number of MED neighbors connecting to the port
Number of CDP neighbors Number of the CDP neighbors connecting to the port
Number of sent optional TLV
Number of the optional TLVs contained in an LLDPDU sent through the
port
Number of received unknown TLV Number of the unknown TLVs contained in a received LLDPDU
display lldp tlv-config
Syntax
display lldp tlv-config [ interface interface-type interface-number ]
View
Any view
Default level
1: Monitor level
Parameters
interface interface-type interface-number: Specifies a port by its type and number.
Description
Use the display lldp tlv-config command to display the types of advertisable optional LLDP TLVs of a
port.
If no port is specified, this command displays the types of advertisable optional TLVs of each port.
Examples
# Display the types of advertisable optional LLDP TLVs of each port.
<Sysname> display lldp tlv-config
LLDP tlv-config of port 1[GigabitEthernet1/0/1]:
NAME STATUS DEFAULT
Basic optional TLV:
Port Description TLV YES YES
System Name TLV YES YES
System Description TLV YES YES
System Capabilities TLV YES YES

H3C S5120-SI Series Specifications

General

Brand	H3C
Model	S5120-SI Series
Category	Switch
Language	English