H3C S5120-SI Series

1-15
<Sysname> system-view
[Sysname] port-group manual group1
[Sysname-port-group-manual-group1] group-member gigabitethernet 1/0/1
interface
Syntax
interface interface-type interface-number
View
System view
Default Level
2: System level
Parameters
interface-type: Interface type.
interface-number: Interface number.
Description
Use the interface command to enter interface view.
Examples
# Enter GigabitEthernet 1/0/1 interface view.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1]
jumboframe enable
Syntax
jumboframe enable
undo jumboframe enable
View
System view
Default Level
2: System level
Parameters
None
Description
Use the jumboframe enable command to allow jumbo frames with 10240 bytes to pass through an
Ethernet port.