1-6
Parameters
hello-time: Interval to send NDP packets, in the range 5 to 254 seconds.
Description
Use the ndp timer hello command to set the interval to send NDP packets.
Use the undo ndp timer hello command to restore the default.
By default, the interval to send NDP packets is 60 seconds.
Note that the interval for sending NDP packets cannot be longer than the time for the receiving device to
hold NDP packets; otherwise, the NDP table may become instable.
Related commands: ndp timer aging.
Examples
# Set the interval to send NDP packets to 80 seconds.
<Sysname> system-view
[Sysname] ndp timer hello 80
reset ndp statistics
Syntax
reset ndp statistics [ interface interface-list ]
View
User view
Default Level
2: System level
Parameters
interface interface-list: Specifies an Ethernet port list, which can contain multiple Ethernet ports. The
interface-list argument is in the format of interface-list = { interface-type interface-number [ to
interface-type interface-number ] } & <1-10>, where interface-type represents the port type,
interface-number represents the port number, and & <1-10> means that you can provide up to 10 port
indexes/port index lists for this argument. If you provide this keyword, NDP statistics of the specified
port will be cleared; otherwise, NDP statistics of all ports will be cleared.
Description
Use the reset ndp statistics command to clear NDP statistics.
Examples
# Clear NDP statistics of all ports.
<Sysname> reset ndp statistics
To Next Page
Loading...
Need help?
General