1-9
[Sysname-isp-system] authentication login local
# Configure ISP domain test to use RADIUS authentication scheme rd for login users and use local
authentication as the backup.
<Sysname> system-view
[Sysname] domain test
[Sysname-isp-test] authentication login radius-scheme rd local
authorization command
Syntax
authorization command { local | none }
undo authorization command
View
ISP domain view
Default Level
2: System level
Parameters
local: Performs local authorization.
none: Does not perform any authorization. In this case, an authenticated user is automatically
authorized with the corresponding default rights.
Description
Use the authorization command command to configure the authorization method for command line
users.
Use the undo authorization command command to restore the default.
By default, the default authorization method is used for command line users.
Note that: For local authorization, the local users must have been configured for the command line
users on the device, and the level of the commands authorized to a local user must be lower than or
equal to that of the local user. Otherwise, local authorization will fail.
Related commands: authorization default.
Examples
# Configure the default ISP domain system to use local authorization for command line users.
<Sysname> system-view
[Sysname] domain system
[Sysname-isp-system] authorization command local
authorization default
Syntax
authorization default { local | none | radius-scheme radius-scheme-name [ local ] }
undo authorization default
To Next Page
Loading...
Need help?
General