EasyManuals Logo

H3C S5120-SI Series Command Reference

H3C S5120-SI Series
910 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #356 background imageLoading...
Page #356 background image
1-6
[Sysname-acl-basic-2000] rule permit source 225.1.1.1 0
[Sysname-acl-basic-2000] quit
[Sysname] igmp-snooping
[Sysname-igmp-snooping] group-policy 2000 vlan 2
host-aging-time (IGMP-Snooping view)
Syntax
host-aging-time interval
undo host-aging-time
View
IGMP-Snooping view
Default Level
2: System level
Parameters
interval: Dynamic member port aging time, in seconds. The effective range is 200 to 1,000.
Description
Use the host-aging-time command to configure the aging time of dynamic member ports globally.
Use the undo host-aging-time command to restore the default setting.
By default, the aging time of dynamic member ports is 260 seconds.
This command works only on IGMP snooping–enabled VLANs.
Related commands: igmp-snooping host-aging-time.
Examples
# Set the aging time of dynamic member ports globally to 300 seconds.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] host-aging-time 300
igmp-snooping
Syntax
igmp-snooping
undo igmp-snooping
View
System view
Default Level
2: System level

Table of Contents

Other manuals for H3C S5120-SI Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the H3C S5120-SI Series and is the answer not in the manual?

H3C S5120-SI Series Specifications

General IconGeneral
BrandH3C
ModelS5120-SI Series
CategorySwitch
LanguageEnglish

Related product manuals