2-4
Use the undo data-flow-format command to restore the default.
By default, the unit for data flows is byte and that for data packets is one-packet.
Note that:
z The specified unit of data flows sent to the RADIUS server must be consistent with the traffic
statistics unit of the RADIUS server. Otherwise, accounting cannot be performed correctly.
z You can use these commands to change the settings only when no user is using the RADIUS
scheme.
Related commands: display radius scheme.
Examples
# Define RADIUS scheme radius1 to send data flows and packets destined for the RADIUS server in
kilobytes and kilo-packets.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] data-flow-format data kilo-byte packet kilo-packet
display radius scheme
Syntax
display radius scheme [ radius-scheme-name ]
View
Any view
Default Level
2: System level
Parameters
radius-scheme-name: RADIUS scheme name.
Description
Use the display radius scheme command to display the configuration information of a specified
RADIUS scheme or all RADIUS schemes.
Note that: If no RADIUS scheme is specified, the command will display the configuration information of
all RADIUS schemes.
Related commands: radius scheme.
Examples
# Display the configurations of all RADIUS schemes.
<Sysname> display radius scheme
------------------------------------------------------------------
SchemeName : radius1
Index : 0 Type : extended
Primary Auth Server:
IP: 1.1.1.1 Port: 1812 State: block
To Next Page
Loading...
Need help?
General