1-13
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] apply poe-profile name abc
poe legacy enable
Syntax
poe legacy enable
undo poe legacy enable
View
System view
Default Level
2: System level
Parameters
pse pse-id: Specifies a PSE ID.
Description
Use the poe legacy enable command to enable the PSE to detect nonstandard PDs.
Use the undo poe legacy enable command to disable the PSE from detecting nonstandard PDs.
By default, the PSE is disabled from detecting nonstandard PDs.
Examples
# Enable the PSE to detect nonstandard PDs (for a device with a single PSE).
<Sysname> system-view
[Sysname] poe legacy enable
poe max-power
Syntax
poe max-power max-power
undo poe max-power
View
PoE interface view, PoE-profile file view
Default Level
2: System level
Parameters
max-power: Maximum power in milliwatts allocated to a PoE interface. The range from 1000 to 30000.
Description
Use the poe max-power command to configure the maximum power for a PoE interface.
Use the undo poe max-power command to restore the default.
To Next Page
Loading...
Need help?
General