H3C S5120-SI Series Command Reference

1-30
Description
Use the storm-constrain enable log command to enable log sending. With log sending enabled, the
system sends logs when traffic reaching a port exceeds the corresponding threshold or when the traffic
drops down below the lower threshold after exceeding the upper threshold.
Use the undo storm-constrain enable log command to disable log sending.
By default, log sending is enabled.
Examples
# Disable log sending for GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] undo storm-constrain enable log
storm-constrain enable trap
Syntax
storm-constrain enable trap
undo storm-constrain enable trap
View
Ethernet port view
Default Level
2: System level
Parameters
None
Description
Use the storm-constrain enable trap command to enable trap message sending. With trap message
sending enabled, the system sends trap messages when traffic reaching a port exceeds the
corresponding threshold or the traffic drops down below the lower threshold after exceeding the upper
threshold.
Use the undo storm-constrain enable trap command to disable trap message sending.
By default, trap message sending is enabled.
Examples
# Disable trap message sending for GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] undo storm-constrain enable trap

H3C S5120-SI Series Specifications

General

Brand	H3C
Model	S5120-SI Series
Category	Switch
Language	English