1-10
[Sysname-GigabitEthernet1/0/1] display connection interface gigabitethernet 1/0/1
Index=68 ,Username=usera@my-domian
MAC=0015-e9a6-7cfe ,IP=3.3.3.3
Total 1 connection(s) matched.
dot1x max-user
Syntax
In system view:
dot1x max-user user-number [ interface interface-list ]
undo dot1x max-user [ interface interface-list ]
In Ethernet interface view:
dot1x max-user user-number
undo dot1x max-user
View
System view, Ethernet interface view
Default Level
2: System level
Parameters
user-number: Maximum number of users to be supported simultaneously. It ranges from 1 to 256.
interface interface-list: Specifies an Ethernet port list, which can contain multiple Ethernet ports. The
interface-list argument is in the format of interface-list = { interface-type interface-number [ to
interface-type interface-number ] } & <1-10>, where interface-type represents the port type,
interface-number represents the port number, and & <1-10> means that you can provide up to 10 port
indexes/port index lists for this argument. The start port number must be smaller than the end number
and the two ports must be of the same type.
Description
Use the dot1x max-user command to set the maximum number of users an Ethernet port can support
simultaneously.
Use the undo dot1x max-user command to restore the default.
In system view:
z If you do not specify the interface-list argument, execution of the command applies to all ports.
z If you specify the interface-list argument, execution of the command applies to the specified ports.
In Ethernet port view, the interface-list argument is not available and the command applies to only the
current port.
Related commands: display dot1x.
Examples
# Set the maximum number of users for port GigabitEthernet 1/0/1 to support simultaneously as 32.
To Next Page
Loading...
Need help?
General