1-11
By default, all the ports are allowed to generate port link up/down logging information when the port
state changes.
Examples
# Disable port Vlan-interface1 from generating link up/down logging information.
<Sysname> system-view
[Sysname] interface vlan-interface1
[Sysname- Vlan-interface1] undo enable log updown
info-center channel name
Syntax
info-center channel channel-number name channel-name
undo info-center channel channel-number
View
System view
Default Level
2: System level
Parameters
channel-number: Specifies a channel number, in the range 0 to 9.
channel-name: Specifies a channel name, a string of 1 to 30 characters. It must be a combination of
letters and numbers, and start with a letter and is case insensitive.
Description
Use the info-center channel name command to name a channel with a specified channel number.
Use the undo info-center channel command to restore the default name for a channel with a specified
channel number.
Refer to Table 1-1
for details of default channel names and channel numbers.
Examples
# Name channel 0 as abc.
<Sysname> system-view
[Sysname] info-center channel 0 name abc
info-center console channel
Syntax
info-center console channel { channel-number | channel-name }
undo info-center console channel
View
System view
To Next Page
Loading...
Need help?
General