1-19
The TTL multiplier defaults to 4.
You can set the TTL of the local device information by configuring the TTL multiplier.
The TTL of the information about a device is determined by the following expression:
TTL multiplier × LLDPDU transmit interval
Note that the TTL can be up to 65535 seconds. TTLs longer than 65535 will be rounded off to 65535
seconds.
Related commands: lldp timer tx-interval.
Examples
# Set the TTL multiplier to 6.
<Sysname> system-view
[Sysname] lldp hold-multiplier 6
lldp management-address-format string
Syntax
lldp management-address-format string
undo lldp management-address-format
View
Layer 2 Ethernet port view, port group view
Default Level
2: System level
Parameters
None
Description
Use the lldp management-address-format string command to encapsulate the management
address in the form of strings in TLVs.
Use the undo lldp management-address-format command to restore the default.
By default, the management address is encapsulated in the form of numbers in TLVs.
Examples
# Configure GigabitEthernet 1/0/1 to encapsulate the management address in the form of strings in
management address TLVs.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lldp management-address-format string
lldp management-address-tlv
Syntax
lldp management-address-tlv [ ip-address ]
To Next Page
Loading...
Need help?
General