1-12
Examples
# Set the PD disconnection detection mode to dc.
<Sysname> system-view
[Sysname] poe disconnect dc
poe enable
Syntax
poe enable
undo poe enable
View
PoE interface view, PoE-profile file view
Default Level
2: System level
Parameters
None
Description
Use the poe enable command to enable PoE on a PoE interface.
Use the undo poe enable command to disable PoE on a PoE interface.
By default, PoE is disabled on a PoE interface.
z If a PoE configuration file is already applied to a PoE interface, you need to remove the
application of the file to the PoE interface before configuring the interface in PoE-profile view.
z If a PoE configuration file is applied to a PoE interface, you need to remove the application of the
file to the PoE interface before configuring the interface in PoE interface view.
Examples
# Enable PoE on a PoE interface.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] poe enable
# Enable PoE on a PoE interface through a PoE configuration file.
<Sysname> system-view
[Sysname] poe-profile abc
[Sysname-poe-profile-abc-1] poe enable
[Sysname-poe-profile-abc-1] quit
To Next Page
Loading...
Need help?
General