1-13
CTRL_W Delete the word left of the cursor.
CTRL_X Delete all characters up to the cursor.
CTRL_Y Delete all characters after the cursor.
CTRL_Z Return to the User View.
CTRL_] Kill incoming connection or redirect connection.
ESC_B Move the cursor one word back.
ESC_D Delete remainder of word.
ESC_F Move the cursor forward one word.
ESC_N Move the cursor down a line.
ESC_P Move the cursor up a line.
ESC_< Specify the beginning of clipboard.
ESC_> Specify the end of clipboard.
display this
Syntax
display this [ by-linenum ]
View
Any view
Default Level
1: Monitor level
Parameters
by-linenum: Specifies to display the number of each line.
Description
Use the display this command to display the validated configuration information under the current
view.
After finishing a set of configurations under a view, you can use the display this command to check
whether the configuration takes effect.
Note that:
z A parameter is not displayed if it has the default configuration.
z A parameter is not displayed if the configuration has not taken effect.
z Execution of this command in any user interface view displays the valid configuration in all the user
interfaces.
z Execution of this command in any VLAN view displays the configurations of all the created VLANs.
Examples
# Display the valid configuration information on interface GigabitEthernet1/0/1 (the output information
depends on the current configuration of the device).
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-gigabitethernet 1/0/1] display this
#
To Next Page
Loading...
Need help?
General