1-14
View
Ethernet port view
Default Level
2: System level
Parameters
interval: Interval at which the interface collects statistics. It ranges from 5 to 300 seconds and must be a
multiple of 5. The default value is 300 seconds.
Description
Use the flow-interval command to configure the time interval for collecting interface statistics.
Use the undo flow-interval command to restore the default interval.
Examples
# Set the time interval for collecting interface statistics to 100 seconds.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] flow-interval 100
group-member
Syntax
group-member interface-list
undo group-member interface-list
View
Port group view
Default Level
2: System level
Parameters
interface-list: Ethernet port list, in the form of interface-type interface-number [ to interface-type
interface-number ] &<1-10>, where &<1-10> indicates that you can specify up to 10 port or port ranges.
Description
Use the group-member command to assign an Ethernet port or a list of Ethernet ports to the port
group.
Use the undo group-member command to remove an Ethernet port or a list of Ethernet ports from the
port group.
By default, there is no Ethernet port in a port group.
Examples
# Add interface GigabitEthernet 1/0/1 to the port group named group1.
To Next Page
Loading...
Need help?
General