1-26
Parameters
interval: Interval between IGMP last-member queries, in seconds. The effective range is 1 to 5.
Description
Use the last-member-query-interval command to configure the interval between IGMP last-member
queries globally.
Use the undo last-member-query-interval command to restore the default setting.
By default, the interval between IGMP last-member queries is 1 second.
This command works only on IGMP snooping–enabled VLANs.
Related commands: igmp-snooping last-member-query-interval.
Examples
# Set the interval between IGMP last-member queries globally to 3 seconds.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] last-member-query-interval 3
max-response-time (IGMP-Snooping view)
Syntax
max-response-time interval
undo max-response-time
View
IGMP-Snooping view
Default Level
2: System level
Parameters
interval: Maximum response time to IGMP general queries, in seconds. The effective range is 1 to 25.
Description
Use the max-response-time command to configure the maximum response time to IGMP general
queries globally.
Use the undo max-response-time command to restore the default value.
This command works only on IGMP snooping–enabled VLANs.
Related commands: igmp-snooping max-response-time, igmp-snooping query-interval.
Examples
# Set the maximum response time to IGMP general queries globally to 5 seconds.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] max-response-time 5
To Next Page
Loading...
Need help?
General