1-4
Parameters
None
Description
Use the stack role master command to create a stack.
Use the undo stack role master command to remove a stack.
After you execute the stack role master command on a stack-supporting device, the device becomes
the master device of a stack and automatically adds the devices connected with its stack ports to the
stack.
Note that you can remove a stack only on the master device of the stack.
Examples
# Create a stack.
<Sysname> system-view
[Sysname] stack role master
[stack_0.Sysname]
stack stack-port
Syntax
stack stack-port stack-port-num port interface-list
undo stack stack-port stack-port-num port interface-list
View
System view
Default Level
2: System level
Parameters
stack-port-num: Number of stack ports to be configured. The value range varies with the device model
and the number of ports.
interface-list: List of Ethernet ports to be configured as stack ports. You can specify multiple Ethernet
ports by providing this argument in the format of interface-list = { interface-type
interface-number }&<1-n>, where interface-type is the interface type, interface-number is the interface
number, and &<1-n> indicates that you can specify up to n ports or port lists. The value of n equals that
of stack-port-num.
Description
Use the stack stack-port command to configure the specified ports as stack ports.
Use the undo stack stack-port command to remove the configuration.
By default, a port is not a stack port.
Examples
# Configure a stack port on the device and assign port GigabitEthernet 1/0/1 as a stack port.
To Next Page
Loading...
Need help?
General