2-26
timer realtime-accounting (RADIUS scheme view)
Syntax
timer realtime-accounting minutes
undo timer realtime-accounting
View
RADIUS scheme view
Default Level
2: System level
Parameters
minutes: Real-time accounting interval in minutes, zero or a multiple of 3 in the range 3 to 60. The
default is 12.
Description
Use the timer realtime-accounting command to set the real-time accounting interval.
Use the undo timer realtime-accounting command to restore the default.
Note that:
z For real-time accounting, a NAS must transmit the accounting information of online users to the
RADIUS accounting server periodically. This command is for setting the interval.
z When the real-time accounting interval on the device is zero, the device will send online user
accounting information to the RADIUS accounting server at the real-time accounting interval
configured on the server (if any) or will not send online user accounting information.
z The setting of the real-time accounting interval somewhat depends on the performance of the NAS
and the RADIUS server: a shorter interval means higher accounting precision but requires higher
performance. You are therefore recommended to adopt a longer interval when there are a large
number of users (1000 or more). The following table lists the recommended ratios of the interval to
the number of users.
Table 2-3 Recommended ratios of the accounting interval to the number of users
Number of users Real-time accounting interval (minute)
1 to 99 3
100 to 499 6
500 to 999 12
1000 or more 15 or more
Related commands: retry realtime-accounting, radius scheme.
Examples
# Set the real-time accounting interval to 51 minutes for RADIUS scheme radius1.
<Sysname> system-view
[Sysname] radius scheme radius1
To Next Page
Loading...
Need help?
General