1-20
service-port: Port number of the remote FTP server, in the range 0 to 65535, with the default value of
21.
Description
Use the open command to log in to the IPv4 FTP server under FTP client view.
At login, you will be asked to enter the username and password for accessing the FTP server. If your
input is correct, the login succeeds; otherwise, it fails.
If you have logged in to the IPv4 FTP server currently, you cannot use the open command to log in to
another server. You need to disconnect with the current server first, and then try to connect with another
one.
Related commands: close.
Examples
# In FTP client view, log in to the FTP server with the IP address of 192.168.1.50.
<Sysname> ftp
[ftp] open 192.168.1.50
Trying 192.168.1.50 ...
Press CTRL+K to abort
Connected to 192.168.1.50.
220 FTP service ready.
User(192.168.1.50:(none)):aa
331 Password required for aa.
Password:
230 User logged in.
[ftp]
passive
Syntax
passive
undo passive
View
FTP client view
Default Level
3: Manage level
Parameters
None
Description
Use the passive command to set the data transmission mode to passive.
Use the undo passive command to set the data transmission mode to active.
The default transmission mode is passive.
To Next Page
Loading...
Need help?
General