1-25
effect; if you disable the function on the device, the setting of the maximum idle duration parameter
on the server will take effect.
z The user idle threshold parameter can only be set on the device. The server always assigns a user
idle threshold of 10240 bytes to a user. If you set the parameter on the device, the device uses your
setting; otherwise, the device uses that assigned by the server.
Related commands: domain.
Examples
# Enable the idle cut function and set the idle duration threshold to 50 minutes and the traffic threshold
to 1024 bytes for ISP domain test.
<Sysname> system-view
[Sysname] domain test
[Sysname-isp-test] idle-cut enable 50 1024
local-user
Syntax
local-user user-name
undo local-user { user-name | all [ service-type { ftp | lan-access | ssh | telnet | terminal } ] }
View
System view
Default Level
3: Manage level
Parameters
user-name: Name for the local user, a case-sensitive string of 1 to 55 characters that does not contain
the domain name. It cannot contain any backward slash (\), forward slash (/), vertical line (|), colon (:),
asterisk (*), question mark (?), less-than sign (<), greater-than sign (>) and the @ sign and cannot be a,
al, or all.
all: Specifies all users.
service-type: Specifies the users of a type.
z ftp refers to users using FTP.
z lan-access refers to users accessing the network through an Ethernet, such as 802.1X users.
z ssh refers to users using SSH.
z telnet refers to users using Telnet.
z terminal refers to users logging in through the console port, or AUX port.
Description
Use the local-user command to add a local user and enter local user view.
Use the undo local-user command to remove the specified local users.
By default, no local user is configured.
Related commands: display local-user, service-type.
To Next Page
Loading...
Need help?
General