1-4
Reply from 1.1.2.2: bytes=56 Sequence=5 ttl=254 time=1 ms
Record Route:
1.1.2.1
1.1.2.2
1.1.1.2
1.1.1.1
--- 1.1.2.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 1/11/53 ms
The above information indicates the following:
z The destination was reachable.
z The route is 1.1.1.1 <-> {1.1.1.2; 1.1.2.1} <-> 1.1.2.2.
Table 1-1 ping command output description
Field Description
PING 1.1.2.2 Check whether the device with IP address 1.1.2.2 is reachable
56 data bytes Number of data bytes in each ICMP echo request
press CTRL_C to break
During the execution of the command, you can press Ctrl+C to
abort the ping operation.
Reply from 1.1.2.2 : bytes=56
Sequence=1 ttl=255 time=1 ms
Received the ICMP reply from the device whose IP address is
1.1.2.2. If no reply is received during the timeout period, “Request
time out” will be displayed.
z bytes= indicates the number of data bytes in the ICMP reply.
z Sequence= indicates the packet sequence, used to determine
whether a segment is lost, disordered or repeated.
z ttl= indicates the TTL value in the ICMP reply.
z time= indicates the response time.
Record Route:
The routers through which the ICMP echo request passed. They
are displayed in inversed order, that is, the router with a smaller
distance to the destination is displayed first.
--- 1.1.2.2 ping statistics --- Statistics on data received and sent in the ping operation
5 packet(s) transmitted Number of ICMP echo requests sent
5 packet(s) received Number of ICMP echo requests received
0.00% packet loss Percentage of packets not responded to the total packets sent
round-trip min/avg/max = 0/4/20
ms
Minimum/average/maximum response time, in ms. The field is
not available for failed ping attempts in an IPv4 network. In an
IPv6 network, however, the field is available and set to 0/0/0 ms
tracert
Syntax
tracert [ -a source-ip | -f first-ttl | -m max-ttl | -p port | -q packet-number | -w timeout ] * host
To Next Page
Loading...
Need help?
General