1-21
sysname
Syntax
sysname string
undo sysname
View
System view
Default Level
2: System level
Parameters
string: System name of the switch. This argument can contain 1 to 30 characters and defaults to H3C.
Description
Use the sysname command to set a system name for the switch.
Use the undo sysname command to revert to the default system name.
The CLI prompt reflects the system name of a switch. For example, if the system name of a switch is
“H3C”, then the prompt of user view is <H3C>.
Examples
# Set the system name of the switch to ABC.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] sysname ABC
[ABC]
telnet
Syntax
telnet remote-system [ port-number ] [ source { ip ip-address | interface interface-type
interface-number } ]
View
User view
Default Level
0: Visit level
Parameters
remote-system: IP address or host name of the remote system. The host name is a string of 1 to 20
characters, which can be specified using the ip host command.
port-number: TCP port number assigned to Telnet service on the remote system, in the range 0 to
65535.
ip-address: Source IP address of the packets sent by the Telnet client.
To Next Page
Loading...
Need help?
General