1-26
prefer-stoc-cipher: Preferred encryption algorithm from server to client, defaulted to aes128.
prefer-stoc-hmac: Preferred HMAC algorithm from server to client, defaulted to sha1-96.
Description
Use the sftp command to establish a connection to a remote IPv4 SFTP server and enter SFTP client
view.
Note that when the client’s authentication method is publickey, the client needs to get the local private
key for validation. As the publickey authentication includes RSA and DSA algorithms, you must specify
an algorithm (by using the identity-key keyword) in order to get the correct data for the local private key.
By default, the encryption algorithm is DSA.
Examples
# Connect to SFTP server 10.1.1.2, using the following algorithms:
z Preferred key exchange algorithm: dh-group1.
z Preferred encryption algorithm from server to client: aes128.
z Preferred HMAC algorithm from client to server: md5.
z Preferred HMAC algorithm from server to client: sha1-96.
<Sysname> sftp 10.1.1.2 prefer-kex dh-group1 prefer-stoc-cipher aes128 prefer-ctos-hmac md5
prefer-stoc-hmac sha1-96
Input Username:
sftp client source
Syntax
sftp client source { ip ip-address | interface interface-type interface-number }
undo sftp client source
View
System view
Default Level
3: Manage level
Parameters
ip ip-address: Specifies a source IPv4 address.
interface interface-type interface-number: Specifies a source interface by its type and number.
Description
Use the sftp client source command to specify the source IPv4 address or interface of an SFTP client.
Use the undo sftp source-interface command to remove the configuration.
By default, an SFTP client uses the IP address of the interface specified by the route of the device to
access the SFTP server.
Related commands: display sftp client source.
To Next Page
Loading...
Need help?
General