1-2
Description
Use the description command to configure the description of the current VLAN or VLAN interface.
Use the undo description command to restore the default.
For a VLAN, the default description is the VLAN ID, for example, VLAN 0001; for a VLAN interface, the
default description is the name of the interface, for example, Vlan-interface 1 Interface.
You can configure a description to describe the function or connection of a VLAN or VLAN interface for
management sake.
Examples
# Configure the description of VLAN 1 as RESEARCH.
<Sysname> system-view
[Sysname] vlan 1
[Sysname-vlan1] description RESEARCH
# Configure the description of VLAN-interface 2 as VLAN-INTERFACE-2.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] quit
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] description VLAN-INTERFACE-2
display interface vlan-interface
Syntax
display interface vlan-interface [ vlan-interface-id ]
View
Any view
Default Level
1: Monitor level
Parameters
vlan-interface-id: VLAN interface number.
Description
Use the display interface vlan-interface command to display information about a specified or all
VLAN interfaces if no interface is specified.
Related commands: interface vlan-interface.
Examples
# Display the information of VLAN-interface 2.
<Sysname> display interface vlan-interface 2
Vlan-interface2 current state: DOWN
Line protocol current state: DOWN
Description: Vlan-interface2 Interface
To Next Page
Loading...
Need help?
General