1-25
[Sysname-Gigabitethernet1/0/1] igmp-snooping static-router-port vlan 2
igmp-snooping version
Syntax
igmp-snooping version version-number
undo igmp-snooping version
View
VLAN view
Default Level
2: System level
Parameters
version-number: IGMP snooping version, in the range of 2 to 3.
Description
Use the igmp-snooping version command to configure the IGMP snooping version.
Use the undo igmp-snooping version command to restore the default setting.
By default, the IGMP snooping version is 2.
Note that: This command can take effect only if IGMP snooping is enabled in the VLAN.
Related commands: igmp-snooping enable.
Examples
# Enable IGMP snooping in VLAN 2, and set the IGMP snooping version to version 3.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping version 3
last-member-query-interval (IGMP-Snooping view)
Syntax
last-member-query-interval interval
undo last-member-query-interval
View
IGMP-Snooping view
Default Level
2: System level
To Next Page
Loading...
Need help?
General