1-39
Description
Use the ftp-server command to configure a public FTP server (by setting its IP address, username, and
password) on the management device for the member devices in the cluster.
Use the undo ftp-server command to remove the FTP server configured for the member devices in the
cluster.
By default, a cluster is not configured with a public FTP server.
Note that the command can be executed on the management device only.
Examples
# Set the IP address, username and password of an FTP server shared by the cluster on the
management device to be 1.0.0.9, ftp, and in plain text respectively.
<Sysname> system-view
[Sysname] cluster
[Sysname-cluster] ip-pool 10.1.1.1 24
[Sysname-cluster] build aaa
[aaa_0.Sysname-cluster] ftp-server 1.0.0.9 user-name ftp password simple ftp
holdtime
Syntax
holdtime hold-time
undo holdtime
View
Cluster view
Default Level
2: System level
Parameters
hold-time: Holdtime in seconds, in the range 1 to 255.
Description
Use the holdtime command to configure the holdtime of a device.
Use the undo holdtime command to restore the default.
By default, the holdtime of a device is 60 seconds.
Note that:
z This command can be executed on the management device only.
z The configuration is valid on all member devices in a cluster.
Examples
# Set the holdtime to 30 seconds on the management device.
<Sysname> system-view
[Sysname] cluster
To Next Page
Loading...
Need help?
General