1-41
View
Cluster view
Default Level
2: System level
Parameters
ip-address: IP address of the logging host.
Description
Use the logging-host command to configure a logging host shared by a cluster.
Use the undo logging-host command to remove the logging host configuration.
By default, no logging host is configured for a cluster.
Note that:
z This command can be executed on the management device only.
z You have to execute the info-center loghost command in system view first for the logging host
you configured to take effect.
For related configuration, refer to the info-center loghost command in Information Center Commands.
Examples
# Configure the IP address of the logging host shared by a cluster on the management device as
10.10.10.9.
<Sysname> system-view
[Sysname] cluster
[Sysname-cluster] ip-pool 10.1.1.1 24
[Sysname-cluster] build aaa
[aaa_0.Sysname-cluster] logging-host 10.10.10.9
management-vlan
Syntax
management-vlan vlan-id
undo management-vlan
View
System view
Default Level
2: System level
Parameters
vlan-id: ID of the management VLAN, which ranges from 1 to 4094.
Description
Use the management-vlan command to specify the management VLAN.
To Next Page
Loading...
Need help?
General