2-1
2 RADIUS Configuration Commands
RADIUS Configuration Commands
accounting-on enable
Syntax
accounting-on enable
undo accounting-on enable
View
RADIUS scheme view
Default Level
2: System level
Parameters
None
Description
Use the accounting-on enable command to enable the accounting-on feature. After doing so, when
the device reboots, an accounting-on message will be sent to the RADIUS server to log out the online
users of the device.
Use the undo accounting-on enable command to disable the accounting-on feature.
By default, the accounting-on feature is disabled.
Note that:
z Execution of this command does not affect the results of other accounting-on related commands
such as accounting-on enable send.
z When you execute the accounting-on enable command, if the system has another authentication
scheme already enabled with the accounting-on feature, the command takes effect immediately.
Otherwise, you need to save the configuration by using the save command, so that the command
takes effect after the device reboots. For information about the save command, refer to File System
Management Commands.
Related commands: radius scheme.
Examples
# Enable the accounting-on feature for RADIUS authentication scheme rd.
<Sysname> system-view
[Sysname] radius scheme rd
[Sysname-radius-rd] accounting-on enable
To Next Page
Loading...
Need help?
General