2-16
radius trap
Syntax
radius trap { accounting-server-down | authentication-server-down }
undo radius trap { accounting-server-down | authentication-server-down }
View
System view
Default Level
2: System level
Parameters
accounting-server-down: RADIUS trap for accounting servers.
authentication-server-down: RADIUS trap for authentication servers.
Description
Use the radius trap command to enable the RADIUS trap function.
Use the undo radius trap command to disable the function.
By default, the RADIUS trap function is disabled.
Note that:
z If a NAS sends an accounting or authentication request to the RADIUS server but gets no response,
the NAS retransmits the request. With the RADIUS trap function enabled, when the NAS transmits
the request for half of the specified maximum number of transmission attempts, it sends a trap
message; when the NAS transmits the request for the specified maximum number, it sends another
trap message.
z If the specified maximum number of transmission attempts is odd, the half of the number refers to
the smallest integer greater than the half of the number.
Examples
# Enable the RADIUS trap function for accounting servers.
<Sysname> system-view
[Sysname] radius trap accounting-server-down
reset radius statistics
Syntax
reset radius statistics
View
User view
Default Level
2: System level
To Next Page
Loading...
Need help?
General